Chevy TrailBlazer, TrailBlazer SS and GMC Envoy Forum banner

P1514 and pending P0300

[SOLVED] 
10K views 8 replies 6 participants last post by  pdcomm 
#1 ·
Hi I'm new to this thread and I have a 02 trailblazer.recently i replaced the sparkplugs and now im getting a p1514 and a pending code p0300 i checked and cleand the throttle body and did not find any problems. I started my TB and it ran fine at idle but until i took it out engine light came on and reduce engine power and now it idles rough.any ideas on what to look for.
 
#3 ·
You removed the throttle body from the engine, cleaned BOTH sides, and had the battery disconnected for at least 35-40 minutes while doing the cleaning?
 
#5 ·
Huh??? :confused:

OP hasn't responded to any questions/suggestions, but it says "solved" on the thread title. Real nice when posters come here looking for help, get help, fix their problem, but offer no thanks for it. :mad:
 
#6 ·
Po306

I was wondering if anyone has new information regarding PO306, my MIL is constantly on now. In the past it would show up occasionally, perhaps once every couple of months. These are the things that I did, swapped coils, put in the AC Delco Iridium 41-103 spark plugs, new air filter, removed the throttle body and cleaned it on both sides and pulled the two PCM fuses and waited 30 minutes. At that time which was a few months ago everything was fine. Other than the code the TB has a slightly rough idle, but has great power for a vehicle with 174,000 mi.
 
#7 ·
[QUOTE = "chavez94, post: 1172837, member: 57746"]
Привет, я новичок в этой теме, и у меня есть 02 trailblazer. Недавно я заменил свечи зажигания, и теперь я получаю p1514 и ожидающий код p0300, я проверил и очистил корпус дроссельной заслонки и не обнаружил никаких проблем. Я запустил свой TB, и он работал нормально на холостом ходу, но пока я не вытащил его, загорелся свет двигателя и уменьшил мощность двигателя, и теперь он грубо работает на холостом ходу. Есть идеи, что искать.
[/ЦИТИРОВАТЬ]
 
#8 ·
[QUOTE = "Turta9, сообщение: 1626924, участник: 385664"]
[QUOTE = "chavez94, post: 1172837, member: 57746"]
Привет, я новичок в этой теме, и у меня есть 02 первопроходец. Недавно я заменил свечи зажигания, и теперь я получаю p1514 и ожидающий код p0300, я проверил и очистил корпус дроссельной заслонки и не обнаружил никаких проблем. Я запустил свой TB, и он работал нормально на холостом ходу, но пока я не вытащил его, загорелся свет двигателя и уменьшил мощность двигателя, и теперь он грубо работает на холостом ходу. Есть идеи, что искать.
[/ ЦИТИРОВАТЬ]
[/ЦИТИРОВАТЬ]
Добрый день решился вопрос по ошибке p1514 или ? Просто у меня такая же проблема
 
#9 ·
[QUOTE = "Turta9, сообщение: 1626924, участник: 385664"]
[QUOTE = "chavez94, post: 1172837, member: 57746"]
Привет, я новичок в этой теме, и у меня есть 02 первопроходец. Недавно я заменил свечи зажигания, и теперь я получаю p1514 и ожидающий код p0300, я проверил и очистил корпус дроссельной заслонки и не обнаружил никаких проблем. Я запустил свой TB, и он работал нормально на холостом ходу, но пока я не вытащил его, загорелся свет двигателя и уменьшил мощность двигателя, и теперь он грубо работает на холостом ходу. Есть идеи, что искать.
[/ ЦИТИРОВАТЬ]
[/ЦИТИРОВАТЬ]
Добрый день решился вопрос по ошибке p1514 или ? Просто у меня такая же проблема
Translated^ :
"Good afternoon, the question was resolved by mistake p1514 or? I just have the same problem" .
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top