Chevy TrailBlazer, TrailBlazer SS and GMC Envoy Forum banner

Trailblazer SS Jack Points

12K views 3 replies 4 participants last post by  iowapack 
#1 ·
Hello All,
I was going to paint my Calipers today,but i am having a difficult time finding stable jack points to jack up the truck.I tried 2 solid looking places on the frame but everytime i would start to jack it looked like it was going to bend it.Any help would be greatly appreciated.
 
#4 ·
What jack points? I've never seen a vehicle this hard to jack up before, and I've done it a few times now rotating tires. The frame is so rigid, there's places you can jack one point and lift three corners! I don't worry about bending the frame anymore, I don't think it's possible. I just jack it far enough away from the wheel well to get a stand under as far forward or rear as possible. I start at the rear, go side to side, and then rear to front. Once all four are up, she's solid as a rock.

John
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top